One of the easiest, cheapest ways to fight climate change may be shining down on you right now. The bulbs you use in your kitchen ceiling, chandelier, bedside lamp, or bathroom vanity can be either a major energy suck or a smart way to lighten your power load.
Incandescent light bulbs were a revelation when they were introduced by Thomas Edison in the late 19th century, but those bulbs were so inefficient that up to 90 percent of the energy they used was wasted as heat. These were the only option until 1980, when compact fluorescent lamps (known as CFLs) hit the market as a more efficient alternative. The early CFLs were not only prohibitively expensive but also too bulky for most lamps, and slow to fully light up. But over the next 20 years, CFLs improved dramatically.
A newer, more efficient halogen version, which used 25 percent to 30 percent less power than the old incandescents, became available in 2007. More recently, engineers have perfected the light-emitting diode (LED) light bulb (originally introduced in 1962) and in the past five years, LEDs have come a long way. Today, they are by far the best bet in terms of performance and energy savings, says Noah Horowitz, director of NRDC’s Center for Energy Efficiency Standards in the Climate & Clean Energy Program. (As a result, CFL bulbs are increasingly being phased out of the marketplace.) And the design innovations, combined with legal mandates, have cut our energy demand for lighting way, way back. In fact, until recently, lighting represented 15 percent of all residential electricity use, and dozens of extra power plants had to operate in order to keep those incandescent bulbs burning, Horowitz says. Now, as the Trump administration attempts to roll back some of our lighting regulations, it’s even more important to do your part for the climate and keep your sockets planet-friendly.
Do the Math
The average home has more than 40 light sockets. Should you add up all the bulbs lighting up your place and find yourself with a similar number, consider this: If you’re using incandescents and replace them all with LED bulbs, you’ll save more than $100 per year. Nationally, if all households phased out their incandescents and halogens, it would break down to an annual savings of $12 billion.
When purchased in a multipack, LEDs that replace 60-watt incandescents are around $2 per bulb. LEDs are 85 percent more efficient than old incandescents, needing only around 10 watts (units of power) to deliver the same amount of light as the old 60-watt bulb.
Decode the Labels
Back when incandescents reigned, people got used to selecting light bulbs based on their wattage, even though that measurement referred to energy usage, not brightness. Now all bulbs come with information about the bulb’s lumens—a measure of the quantity of light—printed on the label. (The higher the lumens, the brighter the light.) To help consumers used to reading wattage levels, LED manufacturers usually include the incandescent-equivalent wattage on the package too. For example, the package might also say “60W replacement,” even though the LED likely uses only 9 or 10 watts.
While different brands use different terms, LED packages will always include a lighting facts label with a sliding scale indicating whether the bulb is “warm” or “cool.” Warm, or “soft white,” is reminiscent of the yellowish glow emitted by incandescents. At the other end of the spectrum, “cool white” gives off a light that’s slightly blue. You’ll find these qualities measured via the Kelvin scale, with bulbs ranging from around 2,700 to 3,000 Kelvin emitting warm light and 5,000 to 6,000 Kelvin producing bluish light. If you’re not sure which you prefer, try one of each. “See which one you like before buying 30 bulbs and retrofitting the whole house,” Horowitz says.
Whenever possible, Horowitz recommends you choose bulbs that have earned the U.S. Environmental Protection Agency’s Energy Star. If a manufacturer’s bulb has earned the star, it means that it meets a long list of requirements: It dims well, it doesn’t flicker, and it gives off a good light color—all while meeting strict energy efficiency standards. “It's kind of an implicit endorsement that the bulb will be longer lasting,” Horowitz adds.
Make Some Swaps
If you’ve got incandescent or halogen bulbs, Horowitz suggests replacing them with LEDs even before those bulbs burn out. (The exception would be for older bulbs in places like closets or basements, where they’re used only occasionally.) “LEDs are a perfect one-for-one replacement for an incandescent,” Horowitz says. “They do everything the incandescent can do with the exception of one thing: They don’t waste energy.” If you have CFLs and you’re happy with them, keep using them for the rest of their lifetime, since LEDs are only slightly more efficient. But if you’re not very fond of your CFLs—say, because they don’t dim or you find the light they cast unflattering—go ahead and switch them out.
Dispose of Your Old Bulbs Properly
Incandescent and halogen light bulbs can be tossed out, since they don’t contain any hazardous materials. Due to the small amounts of mercury contained in CFLs, however, those should be sealed into a Ziploc bag and brought to a local recycling center or a hardware store like Home Depot or Lowe’s. You can find the recycling center closest to you here.
And when your LEDs eventually burn out, you can put those in the trash too, since they don’t contain any hazardous materials. Because they do have some electronics in the base, these bulbs may be recyclable in the future, assuming new systems will be introduced to better dispose of these materials.
Light bulb legislation matters for the planet. In 2007, President George W. Bush signed the Energy Independence and Security Act, which mandated minimum efficiency standards that would gradually phase out every inefficient bulb in the more than six billion sockets in America. As a direct result, when the first phase of the rules took effect in 2012, many people swapped their old incandescents for halogen bulbs, each of which used 28 percent less power. More recently there’s been a surge in LED sales, thanks to the vast number of affordable options on the market, with manufacturers spurred by the new efficiency standards to keep innovating. (Hundreds of different varieties of LED bulbs currently meet the requirements.)
Unfortunately, the Trump administration is intent on scuttling this progress. Earlier this year, bowing to lobbying pressure by industry groups including the National Electrical Manufacturers Association, the U.S. Department of Energy (DOE) proposed rolling back light bulb regulations. Specifically, the DOE wants to exempt several types of incandescent and halogen light bulbs (such as three-way, reflector, and candle-shaped candelabra bulbs)—which collectively amount to nearly half of bulbs sold—from the next stage of the regulatory update, slated for 2020. If this happens, it will cost the nation $12 billion in lost savings in 2025 alone. It will also position the United States to become a dumping ground for inefficient light bulbs. That’s because while incandescents and halogens have already been phased out in Europe and will be in many other countries in the near future, they are still being manufactured in places like Mexico and China. And because they’re nominally cheaper up front than LEDs, many consumers may continue to buy incandescents and halogens if they’re available, despite their higher long-term cost.
If the DOE succeeds in stymieing these efficiency standards, the estimated 2.7 billion sockets that still house incandescent or halogen light bulbs in this country may not be replaced by energy-saving LEDs. Failure to replace those bulbs would mean that an additional 25 coal-burning power plants’ worth of electricity would have to be generated, producing 34 million tons of extra carbon emissions each year.
What you can do: Change the incandescent light bulbs in your home to LEDs, and encourage your neighbors and friends to do the same. You can also contact your local retailers and urge them to stop selling incandescents and halogens as of January 1, 2020. Even if the government does choose to move forward with its promised deregulations, shoppers can take it upon themselves to work toward a more energy-efficient future.
Plus, the EPA wants kudos for complying with a legal settlement, and another Trump official flees into the arms of an oil company.
Want to make your life on campus more eco-friendly? Stand up for our climate with these simple tricks to conserve power, water, and food.
Here’s what you need to know about energy efficiency and how you can help save the environment—and money—at the same time.
No demolition required. A few small tweaks to each room could dramatically shrink your carbon footprint.
Noah Horowitz obsesses over the imperceptible ways your television, computer, light bulbs, and dryer are wasting electricity—so you don’t have to.
Dawone Robinson is righting the inequities that low-income communities of color face in accessing the benefits of energy efficiency—like more comfortable homes and lower energy bills, for starters.
Fun fact: In most of the country, there’s a daily auction to sell energy into our power grids—with the least expensive sources winning. Also noteworthy: Coal’s not cheap.
Small steps can add up to big reductions in your electricity use—and your utility bill.
It’s true that aggressive policies and laws are crucial to save the planet. But carbon-cutting actions by individuals can also make a dent (especially when corporations and elected officials take note!). Here are some easy, concrete ways you can make a difference.
Though some online retailers are taking steps to maximize fuel efficiency in their delivery fleets, consumers need to do their part, too.